Radio Go-Box – Assembly (Part 2)

This is a multi part article [1] [2] [X] The case: An older 6U SKB Roto Case with wheels. This case was a nice choice since I had access to one already. The back door doesn’t close super tight since it’s just a plastic cover. It’s enough for now until I want to upgrade this […]

Read more
Changing serial number in SnagIt

Today I purchased a SnagIt license and needed to change the serial number that was being used by my current install. I asked support and it seemed they wanted me to re-install the software. A quick googlin’ and I found an article explaining that the license key was stored in C:\ProgramData\TechSmith\Snagit 13. In this folder […]

Read more
Checking if a TCP port is open

You can use netcat to tell if a TCP port is open on the far end. This isn’t necessarily going to tell you if a service is working but it will let you know that the network port is open from your deivce to the target device. “nc -zv 5.5.5.5 3389” This command would check […]

Read more
Radio Go-Box – Intro (Part I)

I’ve recently acquired a few cables and boxes since starting my adventures in amateur radio. I found that having all the equipment just laying around was kind of annoying. I had try to relegate everything to a single Ikea LACK table but this ended up being fruitless as it didn’t really contain everything nor could […]

Read more